Windows that add space
Bay and bow windows project out from the wall, so they do something no flat window can: they add a little floor area, a seat or a deep sill, and a view along the street as well as straight ahead. They also change the house itself, which is why they deserve more planning than a standard window swap.
Bay or bow?
- A bay window is usually three units: a large center window, often a fixed picture window, set parallel to the wall, with two narrower flanking windows angled back to the house. The flankers are often double-hungs or casements, so the bay opens for air.
- A bow window uses four or more units of equal width set at shallow angles, forming a gentle curve. It projects less sharply and reads softer on the façade, and it is often built with casements for ventilation.
As a rule of thumb, a bay suits a house with crisp lines and a strong center view, and a bow suits a wider wall where you want a sweeping view.
What holds it up
A projecting window hangs out from the wall, and its weight has to be carried. Depending on the size and the house, that is done with a support cable system tied into the framing above, with brackets or knee braces underneath, or with a foundation or framed base built below. The window also needs a roof of its own, or it has to tuck under a deep overhang, and that roof has to be flashed into the wall so water runs off instead of in.
The head board and seat board, the flat panels above and below the glass, are part of the thermal envelope. They should be insulated, and the underside of the seat closed and sealed. An older bay that feels cold at the seat, or has a sagging sill, may have little insulation and a weakened support, and both are worth fixing when the window is replaced.
Replacing an existing bay or bow
Swapping an old bay for a new one in the same opening is the simpler version of this job. The installer checks the existing support, the condition of the seat and the roof flashing, and the framing at the wall. Where water has been getting in, rot can show up in the seat board or at the base of the flankers, and it has to be repaired before the new unit goes in.
Turning a flat window into a bay
Adding a projection where there was a flat window is structural work. The opening may need to grow, a header may have to carry more load, and the new roof and base change the exterior. Ask the contractor how the window will be supported, who handles any permit or plan review with your city or county building department, and whether zoning setbacks apply on a narrow lot. In a Columbus historic district, a new projection on a street-facing wall is an exterior alteration that needs a Certificate of Appropriateness through the city’s historic preservation review.
Choosing the units
- Projection angle: bays are commonly built at 30 or 45 degrees; a steeper angle projects farther and gives a deeper seat.
- Operable flankers: casements catch more breeze, double-hungs keep a traditional look.
- Glass: a bay has a lot of glass facing three directions, so the SHGC of each unit matters; our energy-efficient windows page explains the numbers.
- Interior finish: a stain-grade or paint-grade seat, and whether you want a cushion-depth seat or a plant shelf.
Questions to ask
- How is this window supported, and is that support enough for its weight and size?
- How are the head and seat insulated and sealed?
- How is the roof over the projection flashed into the wall?
- What happens if rot is found in the existing seat or framing?
Start with a look at the wall
A technician looks at the opening, the wall and the existing window before anything is quoted, and you see the price before work starts. Call or text (614) 333-6302, or book online.