Call nowCall (614) 333-6302

Columbus, OH · 55-mile service area

Repair · Columbus

Window repair in Columbus, OH

Most window problems are one failed part: a glass unit that has lost its seal, a worn balance, a broken lock or crank, a cracked pane or a strip of weatherstrip that has flattened out. Fixing that part usually costs less than a new window and keeps the frame and trim you already have. A1 Windows repairs residential windows across Columbus and the communities within about 55 miles.

  • Based in Columbus at 1221 Stimmel Rd
  • Homes within about 55 miles of Columbus
  • We look at the window first; you get the price before work starts
  • Sash
  • Sash balances
  • Sash lock
  • Weatherstrip
  • Insulated glass
3D model · parts we service highlighted · drag or use the arrows to rotate

Signs you need window repair

You might notice…

Safety first. Broken glass can fall from a frame without warning, and the springs inside many balances are under tension. Leave a cracked pane and a sash that drops in place until it’s repaired, and keep children away from both. If your house was built before 1978, its original windows may carry lead paint, and federal EPA rules set lead-safe practices for paid work that disturbs it. Don’t scrape, sand or pry old painted sashes yourself.

  • A sash that sticks, won’t stay up or drops shut
  • Fog, haze or moisture between the panes
  • Cracked or broken glass
  • A lock that won’t catch or a crank that spins freely
  • Drafts, whistling or daylight around a closed sash
  • Water on the sill or stains on the wall below a window
  • Soft, flaking or rotted wood at the sill or sash

What’s included

Looked at, explained, then fixed.

  • A look at the whole window, not just the part you noticed
  • Glass units, single panes and safety glass replaced where needed
  • Balances, sash cords, pivots and tilt latches repaired or replaced
  • Locks, keepers, cranks, operators and hinges replaced
  • Weatherstripping renewed and the sash adjusted to close tight
  • Localized rot repaired on wood sills and sashes
  • Screens rescreened or replaced
  • A final open-close-lock test before we leave
  1. 01
    Call, text or book

    Tell us which window and what it’s doing. A photo, and the type of window if you know it, helps us bring the right parts.

  2. 02
    We look first

    A technician checks the sash, frame, glass and hardware and finds what has actually failed.

  3. 03
    You see the price

    You get the price for the repair before any work starts, and nothing is done without your go-ahead.

  4. 04
    Fix and test

    We repair the window, then open, close and lock it to make sure it works the way it should.

Pricing

How pricing works

Every window is different: its size, its glass, what has failed and how it is built. So we look at it before we quote, and you get the price before any work starts.

How window pricing works

More on window repair

Most broken windows have one broken part

A window that sticks, drafts, fogs or won’t lock rarely needs to come out of the wall. Usually one component has worn out: a balance, a crank, a seal, a lock or a few inches of rotted sill. Finding that part, and only that part, is the point of a repair visit.

Here is how the common problems map to the work involved:

How a technician works through a window

  1. Operate it. Open, close, tilt and lock the sash while watching where it binds, drops or refuses to seal.
  2. Identify the system. A wood window with cords and weights, a vinyl tilt-in double-hung and a casement with a crank operator fail in different ways and take different parts.
  3. Look at the glass edge. Fog, a white film or streaks between panes point to a failed seal; frost or water on the room side points to indoor humidity instead.
  4. Check the frame. Probe sills and joints for soft wood, look for gaps at the trim and check whether the frame is still square.
  5. Explain and price. You hear what failed, what the repair involves and what it costs before any work starts.

Repair or replace?

Repair usually makes sense when the frame is sound and square, the problem is confined to a part that can be swapped, and the window otherwise seals well. Replacement starts to make more sense when several of these are true at once:

  • The frame or sill is rotted through, not just at the surface.
  • Seals have failed on several sealed units in the same windows, and the sash or frame is also worn.
  • Parts for the window are no longer made and nothing compatible fits.
  • You want a different style, better efficiency or a larger opening anyway.

When replacement is the better call, the next step is window replacement, and a technician measures and looks at the house before quoting.

What Columbus weather does to windows

Columbus has a humid continental climate, with hot, humid summers and cold winters. January’s average daily temperature sits just below freezing, with typical highs above it and lows below it, so winter days keep crossing the freezing mark. That is hard on windows. Wood swells in summer humidity and shrinks in dry winter air, sealants and glazing compound are worked by every warm-cold swing, and water that gets into a joint can freeze and open it further. Severe thunderstorms, most likely in spring, can also bring large hail.

Older homes and historic districts

Two things change how work is done on an older Columbus house. If it was built before 1978, the window paint may contain lead, and EPA’s renovation rule governs paid work that disturbs that paint; window replacement is always covered by it. And in the city’s historic districts, such as German Village, exterior window changes go through design review first. The wood window repair page covers both in more detail.

Before you call

  • Clear dirt and debris out of tracks and sills, then try the sash again.
  • Make sure tilt latches on a tilt-in sash are fully engaged.
  • Wipe the glass on both sides to see whether fog is on a surface or between the panes.
  • Note which windows are affected, the room and the floor. It speeds up the visit.

Leave spring-loaded balances, broken glass and anything above a first-floor sill to a technician. To get a window looked at, call or text (614) 333-6302 or book online.

Call or text · Columbus, OH

Window giving you trouble?

(614) 333-6302
  • You see the price before work starts
  • Columbus-based · 55-mile service area

FAQ

Window repair questions

Call or text (614) 333-6302 if you don’t see your question here.

Is it worth repairing an old window?

Often, yes. If the frame and sash are sound, replacing a failed glass unit, a balance or a lock costs much less than a new window and keeps the trim and finish you already have. When the frame is rotted through or several parts have failed at once, replacement usually makes more sense, and we’ll say so.

Can you repair vinyl windows, or only wood?

Both. Vinyl, aluminum, fiberglass and wood windows all use parts that wear out: balances, locks, latches, weatherstrip and glass units. Many of those parts can be matched or replaced without replacing the window itself.

Why does my window feel drafty when it’s closed?

The usual causes are flattened or missing weatherstrip, a sash that no longer closes all the way because a balance or lock is worn, or gaps in the caulk around the frame. Each of these can be fixed on its own, and fixing the right one makes a noticeable difference in winter.

Do you need to remove the window to repair it?

Usually not. Most repairs, from balances and locks to glass units and weatherstrip, are done with the frame in place. The sash may come out for the repair and goes back in once it’s done.

Can you match parts for an older window?

Often. Balances, locks and operators come in many standard sizes and styles, and the part numbers stamped on old hardware help. Where an exact match no longer exists, a compatible part can usually be fitted.

What should I do if a window won’t close or lock?

Close it as far as it will go and, if it’s on the ground floor, secure it from inside with a wedge or a strip of wood in the track. Then call or text (614) 333-6302 to get the balance, lock or crank repaired.

Can you repair just one window, or do I need a whole-house job?

One window is fine. A single sticking sash or a single foggy unit is a normal repair visit.

What should I have ready before a window repair visit?

Clear a path to the affected windows inside, move furniture and window treatments away from them, and note any manufacturer name or label you can find on the frame, sash or glass spacer. If the problem comes and goes, say when it happens, such as only on cold mornings.

Is it a problem that my house was built before 1978?

Not for getting a window fixed, but it changes how work that disturbs old paint should be done. Federal EPA rules govern paid work that disturbs paint in pre-1978 homes, so ask how dust will be contained and cleaned up before work begins.

Map of Columbus and 51 nearby communities A1 Windows serves within about 55 miles of its shop.

Rivers © OpenStreetMap contributors

Homeowner guides

Guides for window repair in Columbus

All guides

Lock & crank repairNov 21, 2026 · 4 min read

Casement Crank Spinning or Stuck? Operators and Hinges

A casement window opens through a short chain of parts: handle, gearbox, arm, track and hinges. When the crank spins, sticks or grinds, the trick is finding which link in that chain gave out.

Sash & balance repairNov 21, 2026 · 5 min read

Why Your Double-Hung Window Won’t Stay Open

Every double-hung sash is held up by a balance, a counterweight or spring that offsets the weight of the sash. When a sash drops, drifts or slams, the balance is almost always the reason.

Step 1 of 4

Book a window visit

What’s going on with your windows?

Pick the closest match to continue. You can add details on the next step.