Replacing the glass, keeping the window
When a pane cracks or breaks, the frame and sash around it are usually fine. Replacing just the glass keeps the window you have and avoids the cost and disruption of a full replacement. What the job involves depends on what kind of glass the window holds.
Single-pane glass in a wood sash
Older wood windows hold a single pane bedded in glazing putty and held with small metal glazing points. The broken glass and old putty come out, the wood rabbet is cleaned and primed, and a new pane is cut to fit, pointed in and puttied. Traditional putty stays flexible and hardens slowly, and once painted it is what keeps water out of the joint.
Sealed double- or triple-pane units
Most newer windows hold an insulating glass unit: two or three panes sealed around a spacer. A crack in either pane breaks the seal, so the whole unit is replaced. It is measured for width, height and overall thickness and made to order, then set into the existing sash or frame. The same work fixes a unit that has fogged between the panes; see foggy window repair.
Where safety glass is required
The Residential Code of Ohio treats glass in certain spots as a hazardous location that needs safety glazing, such as tempered or laminated glass. Those spots include:
- Glass in doors, and glass close beside a door
- Large panes that sit low to the floor near a walking surface
- Glass near tubs, showers, hot tubs and pools
- Glass along stairways, landings and ramps, and near the bottom of a stair
- Glass in railings and guards
Safety glass in those locations carries a permanent mark, usually etched or fired into a corner, naming the glass type and the standard it meets. If the broken pane sits in one of those spots, replace it with safety glass even if the original was ordinary glass; the building department can confirm what it requires for your house.
Tempered glass is heat-treated so it breaks into small, blunt pieces. Laminated glass has a plastic interlayer that holds the pieces together when it breaks. Ordinary annealed glass breaks into long, sharp shards.
Reading a crack
A break with a clear point of impact and cracks radiating from it was hit by something. A single crack running in from an edge with no impact point is more often a stress crack, which can come from the glass being pinched in its frame or from uneven heating. If the frame is binding the glass, a technician checks and corrects that before setting the new pane, so the new one doesn’t crack the same way.
When the sash is the problem, not the glass
Glass replacement is the right fix when the sash and frame are solid. If the sash is rotted, the frame is out of square, or several sealed units in the same old windows have failed, compare the cost with window replacement. For an older wood sash with soft spots, wood window repair can be done at the same time as the glass.
Until the glass is replaced
- Keep children and pets away from the window and wear gloves near it.
- Don’t pull loose pieces out of the frame by hand; cracked glass can fall unexpectedly.
- Run clear packing tape across a crack on the room side to hold it together.
- If the opening is open to weather or not secure, it may need to be covered; see board-up and storm glass.
Before you call, look in the corners of the glass for an etched mark and see whether you notice two reflections (a sealed unit) or one (a single pane). Then call or text (614) 333-6302 or book online.